Trusted hvac installation for Park City properties. Same-day service available, transparent pricing, and a workmanship guarantee.
A complete HVAC installation from KIC Refrigeration in Park City, KS addresses every element in the comfort chain, from the air handler and condensing unit to the thermostat, ductwork, and filtration system. We ensure proper airflow balance, verified refrigerant charge, tested safety controls, and code-compliant operation before turning the system over to you.
Whether you own a single-family home or manage a commercial property in Park City, professional hvac installation is essential for maintaining safe, efficient indoor climate control. KIC Refrigeration has completed hundreds of hvac installation projects across Kansas, and our Park City customers benefit from that depth of experience, our fully stocked service vehicles, and our ability to respond the same day for urgent situations.
We understand that hvac installation can feel like a major decision. That is why KIC Refrigeration makes the process simple for Park City property owners — free evaluations, transparent pricing, flexible scheduling, and a dedicated point of contact from diagnosis through completion. Your satisfaction is guaranteed.
From initial contact to final verification — here is how we handle hvac installation.
Our Park City estimator walks your property room by room — measuring square footage, checking insulation levels, assessing window area, and inspecting existing ductwork and electrical service. We input all variables into a Manual J load calculation to determine your exact heating and cooling requirements in BTU.
Based on load calculations and your priorities — efficiency, noise level, budget, zoning — we recommend specific equipment and provide a detailed written proposal covering equipment model numbers, SEER2/AFUE ratings, installation scope, warranty, and total cost.
KIC Refrigeration installs HVAC systems in Park City, KS to the highest standards. We set equipment on level, vibration-isolated mounting, braze all refrigerant connections with nitrogen flowing, pressure test with dry nitrogen, evacuate to below 500 microns, charge by weight, seal all duct connections with mastic, and verify gas piping sizing and connections.
Our Park City technician commissions the system by verifying superheat, subcooling, temperature split, static pressure, and gas pressure in heating mode. We program the thermostat, register your manufacturer warranty, label the electrical panel, and walk you through operation and maintenance.
Get answers to the hvac installation questions our customers ask most often.
Complete HVAC installation in Park City ranges from $7,000 to $15,000 for a mid-efficiency furnace and AC combination — typically an 80 percent AFUE furnace paired with a 14.3 to 16 SEER2 condenser. High-efficiency systems with variable-speed blowers and two-stage or variable-speed compressors run $12,000 to $22,000 but deliver significantly lower operating costs and qualify for federal tax credits. Heat pump systems fall between $5,000 and $18,000 depending on whether the system is single-stage, variable-speed, or a dual-fuel configuration. Ductwork modifications or new duct runs add $1,000 to $5,000. KIC Refrigeration provides detailed written proposals for Park City homeowners with every cost itemized and no hidden fees.
Correct HVAC system sizing is determined by a Manual J residential load calculation — the ACCA industry standard — that accounts for your home square footage, ceiling height, insulation R-values, window area and U-factor, air infiltration rate, duct losses, occupancy, and the local KS winter and summer design temperatures. As a rough reference, a well-insulated 2,000-square-foot home in Park City typically needs a 2.5 to 3.5 ton system, while a poorly insulated home of the same size may need 4 tons. KIC Refrigeration never estimates by rule of thumb — we run a proper calculation for your specific Park City home to avoid oversizing, which causes short cycling, high humidity, and premature compressor wear.
A properly installed and maintained HVAC system in Park City typically lasts 15 to 20 years for the gas furnace and 12 to 18 years for the air conditioner or heat pump outdoor unit. Variable-speed equipment tends to last on the higher end of these ranges because it runs at reduced capacity most of the time, causing less thermal and mechanical stress on components. The three biggest factors in equipment lifespan are installation quality, annual professional maintenance, and regular filter changes every 1 to 3 months. KIC Refrigeration offers maintenance plans for Park City homeowners that include seasonal tune-ups, priority scheduling, and repair discounts to help you get the maximum life from your investment.
Yes. KIC Refrigeration pulls all required mechanical, electrical, and gas permits for every HVAC installation in Park City, KS. We prepare the permit application with equipment specifications and installation plans, pay the permit fee, schedule the inspection with the local building department, meet the inspector on-site, and ensure the installation passes all applicable mechanical code requirements. A building permit is not optional — it is required by law in most Park City jurisdictions, and an unpermitted installation can void the manufacturer equipment warranty, create title problems when selling the home, and may not be covered by homeowner insurance if an HVAC failure causes property damage. KIC Refrigeration includes permitting in every installation project.
Hear from property owners who chose us for their heating and cooling needs.
"AC tune-up went well. Found a refrigerant issue I did not know about and topped it off. Fair pricing and honest work."
"KIC Refrigeration installed a new furnace for us last winter. The team was respectful of our home, wore boot covers, and cleaned up everything. Top notch."
"Our mini split stopped cooling mid-summer and they fit us in the next morning. Diagnosed a bad capacitor, replaced it on the spot. Back to normal in under an hour."